100 Rockwell Automation Publication 5094-UM001C-EN-P - April 2019
Chapter 6 Configure the Standard Module
Events Category
The Events category is available only if you choose Data with Events for
Connection in the Module Definition dialog box. Click the + sign next to the
Events category to expand it.
The Events subcategories show the configuration parameters for events.
IMPORTANT You cannot configure events on the Module Properties dialog box. The
parameters that are displayed are read-only.
You must use the Event Output tags to configure an event. For more
information, see Configure an Event in the Event Output Tags
on page 101.
To Next Page
Loading...
Need help?
General
