Rockwell Automation Allen-Bradley FLEX 5000

Rockwell Automation Publication 5094-UM001C-EN-P - April 2019 95
Configure the Standard Module Chapter 6
Connection Category
The Connection category lets you complete the following tasks:
• Set the RPI rate. For more information on the RPI, see Data Types
Available with FLEX 5000 Standard I/O Modules on page 27.
• Set the connection type to use on the EtherNet/IP network.
For more information on unicast and multicast connections, see the
EtherNet/IP Communication Modules in 5000 Series Systems User
Manual, publication ENET-UM004
.
• Inhibit the module. For more information on how to inhibit the module,
see Module Inhibiting
on page 49.
• Configure whether a connection failure while the controller is in Run
module causes a major or minor fault.
TIP The Module Fault area of the Connection category is useful during module
troubleshooting. For more information on the Module Fault area, see
page 131
.