88 Rockwell Automation Publication 5094-UM001C-EN-P - April 2019
Chapter 6 Configure the Standard Module
Before You Begin
You must complete the following tasks before you can configure the module:
1. Create a Logix Designer application project.
2. Add a FLEX 5000 EtherNet/IP adapter to the project.
For more information on how to add a FLEX 5000 EtherNet/IP adapter
to a Logix Designer application project, see the EtherNet/IP
Communication Modules in 5000 Series Systems User Manual,
publication ENET-UM004
.
Create a New Module
After you create a Logix Designer application project and add a FLEX 5000
EtherNet/IP adapter to the project, you can use the following methods to add
modules to the project.
• Discover Modules
• New Module
To Next Page
Loading...
