Rockwell Automation Publication 2071-UM001E-EN-P - November 2013 3
Summary of Changes
This manual contains new and updated information. Changes throughout this
revision are marked by change bars, as shown to the right of this paragraph.
New and Updated
Information
This table contains the changes made to this revision.
Topic Page
Added Kinetix™ 3 system components to work with Connected Components
Workbench software
12
Added Kinetix 3 system components to figures that work with Connected
Components Workbench software
13…14
Added I/O interface diagram 33
Added information to Digital Inputs and Digital Output tables 40…44
Updated Table 30 - 2090-CFBM6DF-CBAAxx Feedback Cable 72
Added reset drive procedure 83
Added Chapter 6 Configure Drive for Communication 85
Added Chapter 7 Configure Your Drive for Communication with a Personal
Computer Running Connected Components Workbench Software
91
Added Reset Drive to Default Values by Using Ultraware Software 102
Added Kinetix 3 to MicroLogix™ and Micro800™ controller interconnect diagrams
for PTO
127
To Next Page
Loading...
Need help?
General
