Instrument Function
R&S
®
SMC100A
91Operating Manual 1411.4060.32 ─ 09
5.2.3.10 Network Settings
The "Network Settings" dialog shows the parameters relevant for identifying the instru-
ment in a network. The R&S SMC is equipped with a network interface and can be
connected to an Ethernet LAN (local area network).
How to connect the signal generator to the network is described in Chapter 2.6.1,
"Connecting the Instrument to the Network", on page 34.
Risk of network errors!
Connection errors can affect the entire network.
If your network does not support DHCP, or if you choose to disable dynamic TCP/IP
configuration, you must assign valid address information before connecting the instru-
ment to the LAN.
Contact your network administrator to obtain a valid IP address.
► To access this dialog, press the SETUP or MENU key and select "Environment >
Network Settings".
In the "Network Settings" dialog, you can configure the settings of the general net-
work environment and specific identification parameters of the instrument in the
network.
The remote commands required to remotely configure the network are described in
Chapter 7.15, "SYSTem Subsystem", on page 347.
Network Status
Indicates that the instrument is connected to the network.
Remote command:
:SYSTem:COMMunicate:NETWork:STATus? on page 354
General Instrument Settings
To Next Page
Loading...
