Instrument Function
R&S
®
SMC100A
83Operating Manual 1411.4060.32 ─ 09
The second part of the menu is a table that lists the installed assemblies. It is divided
into the sections:
●
"Common Assembly"
●
"RF Assembly"
Power On Count
Displays the number of power-on.
Remote command:
:DIAGnostic:INFO:POCount? on page 243
Assembly
The tables list the installed assemblies.
"Assembly"
Assembly name
"Part Number"
Part Number of assembly
"Revision"
Revision state of assembly
Remote command:
:DIAGnostic<hw>:BGINfo? on page 242
5.2.3.3 Software / Options
The "Software/Options" dialog shows the firmware version of the instrument software
and all installed hardware and software options.
Software options purchased at a later stage can be activated with a keycode. The acti-
vation code is supplied with the software option.
How to install options is described in chapter 4 "Software Update / Installing Options"
of the service manual.
The installation of hardware options purchased at a later stage is also described in the
service manual. Most hardware options need to be installed at an authorized
Rohde&Schwarz service shop.
To access the "Software/Options" dialog, select "System" and press the SETUP or
MENU key.
The menu is divided into the following sections:
●
"Firmware"
●
"Hardware Options"
●
"Software Options"
General Instrument Settings
To Next Page
Loading...
