Rohde & Schwarz SMC100A - Hardcopy Options

Instrument Function
R&S
®
SMC100A
108Operating Manual 1411.4060.32 ─ 09
Automatic Naming
Activates automatic generation of the file name. Automatic naming is configured in the
"Options…" sub dialog , see " File Options " on page 108.
Remote command:
:HCOPy:FILE[:NAME]:AUTO:STATe on page 254
File Info
Indicates the file name. The file name can be entered either manually via the file man-
ager (button "File…") or generated automatically (Automatic naming checkbox). Auto-
matic naming is configured in the "Options…" submenu.
Remote command:
:HCOPy:FILE[:NAME] on page 250
:HCOPy:FILE[:NAME]:AUTO:FILE? on page 251
5.2.5.2 Hardcopy Options
This section describes the "Hardcopy Options" dialog.
File Options
Dialog for setting the file parameters.
"Format"
Selects the output file format, for example *.bmp,
*.jpg*.xpm*.png.
Remote command:
:HCOPy:IMAGe:FORMat on page 254
:HCOPy:DEVice:LANGuage on page 249
"Automatic
Naming"
If enabled, creates the output filenames automatically according to
rules following the activated components.
General Instrument Settings