Rohde & Schwarz SMC100A - Display Subsystem

Remote Control Commands
R&S
®
SMC100A
243Operating Manual 1411.4060.32 ─ 09
:DIAGnostic<hw>:BGINfo:CATalog?
Queries the names of the assemblies available in the instrument.
Return values:
<Catalog> string
A complete list of all assemblies is returned (the various entries
are separated by commas). The length of the list is variable and
depends on the instrument equipment configuration.
Example:
DIAG:BGIN:CAT
Queries the names of the assemblies.
Usage: Query only
:DIAGnostic:INFO:OTIMe?
The command queries the number of operation hours.
Return values:
<OTIMe> float
Example:
DIAG:INFO:OTIM
queries the operation hours.
Response: 100023
The instrument was operated for 100023 hours up to now.
Usage: Query only
:DIAGnostic:INFO:POCount?
The command queries the number of power-on events.
Return values:
<Pocount> float
Example:
DIAG:INFO:POC
queries the number of power on events.
Response: 123
The instrument was switched on for 123 times up to now.
Usage: Query only
Manual operation: See "Power On Count" on page 83
7.6 DISPlay Subsystem
The DISPlay subsystem contains the commands to set the power-save mode of the
instrument.
DISPlay Subsystem