Rohde & Schwarz SMC100A - Page 259

Remote Control Commands
R&S
®
SMC100A
244Operating Manual 1411.4060.32 ─ 09
:DISPlay:ANNotation:AMPLitude..................................................................................... 244
:DISPlay:ANNotation:FREQuency....................................................................................244
:DISPlay:ANNotation[:ALL]..............................................................................................244
:DISPlay:DIALog:CLOSe................................................................................................ 245
:DISPlay:DIALog:CLOSe:ALL..........................................................................................245
:DISPlay:DIALog:ID?...................................................................................................... 245
:DISPlay:DIALog:OPEN..................................................................................................245
:DISPlay:PSAVe:HOLDoff...............................................................................................245
:DISPlay:PSAVe[:STATe]................................................................................................246
:DISPlay:UPDate........................................................................................................... 246
:DISPlay:ANNotation:AMPLitude <State>
Indicates asterisks instead of the level values in the status bar.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 1
Example:
DISP:ANN:AMPL ON
Suppresses the level display.
Manual operation: See "Annotation Amplitude" on page 103
:DISPlay:ANNotation:FREQuency <State>
Indicates asterisks instead of the frequency values in the status bar.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 1
Example:
DISP:ANN:FREQ ON
Supresses the frequency display.
Manual operation: See "Annotation Frequency" on page 103
:DISPlay:ANNotation[:ALL] <State>
Displays asterisks instead of the level and frequency values in the status bar of the
instrument. This setting is useful when you remotely control the instrument.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 1
Example:
DISP:ANN:AMPL ON
Shows asterisks instead of frequency and level values.
DISPlay Subsystem