Rohde & Schwarz SMC100A - Source Subsystem; Source:am Subsystem; Sense<Ch>:Unit[:Power]

Remote Control Commands
R&S
®
SMC100A
277Operating Manual 1411.4060.32 ─ 09
:SENSe<ch>:UNIT[:POWer] <Power>
The command selects the unit used for result query with command READ. The power
sensor provides the measured value in Watt. In which unit the measured value is
returned is selected here and might be either Watt, dBm or dBuV.
Parameters:
<Power> DBM | DBUV | WATT
*RST: DBM
Example:
SENS2:UNIT DBM
selects unit dBm for the measured value returned by command
READ.
READ2?
Response: 7.34
7.34 dBm are measured by sensor 2.
Manual operation: See " Unit " on page 151
7.13 SOURce Subsystem
The SOURce subsystem contains the commands for configuring the digital and analog
signals.
SOURce<hw>
For one-path instruments, the keyword SOURce is optional and can be omitted.
● SOURce:AM Subsystem.......................................................................................277
● SOURce:CORRection Subsystem........................................................................279
● SOURce:FM Subsystem.......................................................................................288
● SOURce:FREQuency Subsystem.........................................................................291
● SOURce:INPut Subsystem................................................................................... 298
● SOURce:LFOutput Subsystem............................................................................. 299
● SOURce:MODulation Subsystem......................................................................... 308
● SOURce:PGEN Subsystem..................................................................................308
● SOURce:PHASe Subsystem................................................................................ 309
● SOURce:PM Subsystem.......................................................................................310
● SOURce:POWer Subsystem................................................................................ 312
● SOURce:PULM Subsystem.................................................................................. 323
● SOURce:ROSCillator Subsystem......................................................................... 330
● SOURce:SWEep Subsystem................................................................................332
7.13.1 SOURce:AM Subsystem
The AM subsystem contains the commands for setting the amplitude modulation.
An external modulation signal is input at the MOD EXT connector.
SOURce Subsystem