Rohde & Schwarz SMC100A - [:Source<Hw>]:Sweep[:Frequency]:Running; [:Source<Hw>]:Sweep[:Frequency]:Shape; [:Source<Hw>]:Sweep[:Frequency]:Spacing

Remote Control Commands
R&S
®
SMC100A
336Operating Manual 1411.4060.32 ─ 09
[:SOURce<hw>]:SWEep[:FREQuency]:RUNNing?
Queries the current state of the frequency sweep mode.
Return values:
<State> 0 | 1 | OFF | ON
Example:
SWE:RUNN?
Response "1": signal generation in level sweep active.
Usage: Query only
[:SOURce<hw>]:SWEep[:FREQuency]:SHAPe <Shape>
Sets the cycle mode for a sweep sequence (shape).
Parameters:
<Shape> SAWTooth | TRIangle
SAWTooth
One sweep runs from start to stop frequency. Each subsequent
sweep starts at the start frequency, i.e. the shape of the sweep
sequence resembles a sawtooth.
TRIangle
One sweep runs from start to stop frequency and back, i.e. the
shape of the sweep resembles a triangle. Each subsequent
sweep starts at the start frequency.
*RST: SAWTooth
Example:
SOUR:SWE:SHAP TRI
selects the sweep cycle with alternating ascending and
descending sweep directions.
Manual operation: See " Shape - RF Frequency Sweep " on page 161
[:SOURce<hw>]:SWEep[:FREQuency]:SPACing <Spacing>
Selects the mode for the calculation of the frequency sweep intervals. The frequency
increases or decreases by this value at each step.
The keyword [:FREQuency] can be omitted. Then the command is SCPI-compliant.
SOURce Subsystem