Rohde & Schwarz SMC100A - Source:fm Subsystem

Remote Control Commands
R&S
®
SMC100A
288Operating Manual 1411.4060.32 ─ 09
[:SOURce<hw>]:CORRection:VALue?
Queries the current value for user correction.
Return values:
<Value> float
Range: -100 to 100
Increment: 0.01
*RST: 0
Example:
CORR:VAL?
queries the value currently used for level correction.
Response: -3
the correction value is - 3 dB.
Usage: Query only
Manual operation: See " User Correction Value - User Correction " on page 141
[:SOURce<hw>]:CORRection:ZERoing:STATe <State>
Activates the zeroing procedure before filling the user correction data acquired by a
sensor.
Parameters:
<State> 0 | 1 | OFF | ON
Manual operation: See " Fill User Correction Data with Sensor" on page 146
7.13.3 SOURce:FM Subsystem
The FM subsystem contains the commands for checking the frequency modulation.
Characteristics which are valid for all modulations and the LF Output are configured in
the SOURce:LFOutput subsystem (e.g. frequency). The external signal is input at the
MOD EXT connector.
For information about the required options, see Chapter 5.4.3, "Frequency Modulation
(FM)", on page 173.
[:SOURce<hw>]:FM[:DEViation]...................................................................................... 288
[:SOURce<hw>]:FM:EXTernal:COUPling..........................................................................289
[:SOURce<hw>]:FM:EXTernal:DEViation..........................................................................289
[:SOURce<hw>]:FM:INTernal:DEViation...........................................................................289
[:SOURce<hw>]:FM:SENSitivity?.....................................................................................290
[:SOURce<hw>]:FM:SOURce..........................................................................................290
[:SOURce<hw>]:FM:STATe............................................................................................ 291
[:SOURce<hw>]:FM[:DEViation] <Deviation>
Sets the deviation of the frequency modulation signals in Hz. The maximum deviation
depends on the set RF frequency and the selected modulation mode (see data sheet).
SOURce Subsystem