Instrument Function
R&S
®
SMC100A
82Operating Manual 1411.4060.32 ─ 09
In this dialog you can perform internal calibration routines.
The remote commands required to define these settings are described in Chapter 7.4,
"CALibration Subsystem", on page 240.
Adjust All
Performs all available internal calibration routines of the instrument.
Remote command:
:CALibration<hw>:ALL[:MEASure]? on page 240
Adjust Synthesis
Performs all adjustments which affect the frequency.
Remote command:
:CALibration<hw>:FREQuency[:MEASure]? on page 240
Adjust Level
Performs all adjustments which affect the level. The acquired correction values
improve the settling time and the signal quality.
Remote command:
:CALibration<hw>:LEVel[:MEASure]? on page 241
5.2.3.2 Hardware Config
In the "Hardware Config" dialog, the installed assemblies together with their variants
and revision states can be displayed for servicing purposes.
To open the "Hardware Config" dialog, select "System" and press the SETUP or
MENU key.
Section "Counter" in the upper part of the menu shows the "Operation Time" (in hours)
and the number of power-on ("Power On Counter").
General Instrument Settings
To Next Page
Loading...
