Rohde & Schwarz SMC100A - Putting into Operation

Preparing for Use
R&S
®
SMC100A
24Operating Manual 1411.4060.32 ─ 09
USB CONNECTORS TYPE A
USB (universal serial bus) interfaces of type A (host USB).
●
Connection of peripherals such as mouse, keyboard, etc.
●
Connection of memory stick for file transmission
●
Firmware update
See also Chapter 2.4.1, "Connecting USB Devices", on page 31.
USB IN
USB (universal serial bus) interface of type B (device USB).
This interface can be used for remote control of the instrument.
2.3 Putting into Operation
This section describes the basic steps to be taken when setting up the R&S SMC for
the first time.
Risk of injury and instrument damage
The instrument must be used in an appropriate manner to prevent electric shock, fire,
personal injury, or damage.
●
Do not open the instrument casing.
●
Read and observe the "Basic Safety Instructions" delivered as a printed brochure
with the instrument.
In addition, read and observe the safety instructions in the following sections.
Notice that the data sheet may specify additional operating conditions.
Risk of instrument damage
Note that the general safety instructions also contain information on operating condi-
tions that prevent damage to the instrument. The instrument's data sheet can contain
additional operating conditions.
Putting into Operation