Remote Control Commands
R&S
®
SMC100A
309Operating Manual 1411.4060.32 ─ 09
Example:
PULM:SOUR INT
selects the internal pulse generator as source for pulse modula-
tion
PULM:STAT ON
activates pulse modulation. The pulse generator and the output
of the signals at the PULSE VIDEO connector are automatically
activated in addition.
PGEN:STAT OFF
deactivates the output of the pulse signal by the pulse generator
at the PULSE VIDEO connector. The pulse modulation of the RF
carrier must be activated with command SOURce:PULM:STATe.
Manual operation: See "Video Sync Signal State - Pulse Generator" on page 187
7.13.9 SOURce:PHASe Subsystem
This subsystem contains the commands for adjusting the phase of the RF output signal
relative to a reference signal of the same frequency.
[:SOURce<hw>]:PHASe................................................................................................. 309
[:SOURce<hw>]:PHASe:REFerence................................................................................ 309
[:SOURce<hw>]:PHASe <Phase>
Sets the phase variation relative to the current phase. The variation is specified in
RADians.
Parameters:
<Phase> float
Range: -720 to 720
Increment: 0.1
*RST: 0
Example:
PHAS 0.1 RAD
changes the phase by 0.1 RAD relative to the current phase.
PHAS:REF
adopts the set phase as the current phase.
Manual operation: See "Delta Phase" on page 125
[:SOURce<hw>]:PHASe:REFerence
Adopts the phase set with SOURce:PHASe:ADJust as the current phase.
Example:
PHAS 0.1RAD
changes the phase by 0.1 RAD relative to the current phase.
PHAS:REF
adopts the set phase as the current phase.
Usage: Event
Manual operation: See "Reset Delta Phase Display" on page 125
SOURce Subsystem
To Next Page
Loading...
