Rohde & Schwarz SMC100A - Frequency Settings; RF Frequency Dialog

Instrument Function
R&S
®
SMC100A
123Operating Manual 1411.4060.32 ─ 09
5.3.2.3 RF Frequency Dialog
The combined "RF Frequency / Phase..." dialog contains the parameters required for
configuring the frequency and settings like a frequency offset, or a multiplier factor of
an externally connected multiplier, see Chapter 5.3.2.4, "Frequency Settings",
on page 123.
Furthermore, the dialog provides additional settings parameters which are described
in:
●
Chapter 5.3.3, "Phase", on page 125
5.3.2.4 Frequency Settings
Access:
► Select "RF > config... > RF Frequency > Frequency/Phase".
In the upper section of the combined "RF Frequency / Phase ..." settings dialog,
you can configure the frequency of the RF signal.
The remote commands required to define the settings are described in Chapter 7.13.4,
"SOURce:FREQuency Subsystem", on page 291.
Frequency
Sets the RF frequency of the RF output connector. The frequency entered and dis-
played here corresponds to the frequency at the RF output, that means any offset entry
is not considered.
Note: Suppressed values in the status bar
If the instrument displays asterisks instead of the values, the display has been
disabled for security reasons, see Annotation Frequency and Annotation Amplitude.
RF Block