Rohde & Schwarz SMC100A - Page 302

Remote Control Commands
R&S
®
SMC100A
287Operating Manual 1411.4060.32 ─ 09
Example:
CORR:DEXC:MODE IMP
selects that ASCII files with frequency and level value pairs are
imported and transferred into user correction lists.
CORR:DEXC:AFIL:SEL '/var/user/import_ucor.csv'
selects that ASCII file ucor.csv is imported.
CORR:DEXC:SEL '/var/user/import_ucor_imp'
selects that the ASCII file ucor.csv is imported into user cor-
rection list ucor_imp.
Manual operation: See " Destination / Source - User Correction " on page 144
[:SOURce<hw>]:CORRection:CSET[:SELect]
<Filename>
Selects or creates a file for the user correction data.
If the file does not exist, the instrument automatically creates a new file with the name
you assigned. Note the predefined file extensions under Chapter 4.7.2.1, "Extensions
for User Files", on page 75.
To determine the file location (directory/path) you can either enter it with the command
directly, or use the command MMEMory:CDIR.
To activate level correction use the command [:SOURce<hw>]:CORRection[:
STATe].
Parameters:
<Filename> <table name>
Example:
CORR:CSET '/var/user/ucor1'
selects the table ucor1.
CORR ON
activates level correction. Correction is performed using the
table ucor1.
Manual operation: See " User Cor. Data - User Correction " on page 141
[:SOURce<hw>]:CORRection[:STATe] <State>
Activates/deactivates level correction. Level correction is performed using the table
which has been selected with the command [:SOURce<hw>]:CORRection:CSET[:
SELect].
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example:
SOUR:CORR:CSET '/var/user/ucor1'
selects the table ucor1.
SOUR:CORR ON
activates user correction.
Manual operation: See " State - User Correction " on page 141
SOURce Subsystem