Rohde & Schwarz SMC100A - Page 108

Instrument Function
R&S
®
SMC100A
93Operating Manual 1411.4060.32 ─ 09
Remote command:
:SYSTem:COMMunicate:NETWork:IPADdress on page 353
Subnet Mask
Displays the bit group of the subnet in the host identifier.
To assign the subnet mask manually, select Address Mode "Static".
Remote command:
:SYSTem:COMMunicate:NETWork[:IPADdress]:SUBNet:MASK on page 354
Default Gateway
Displays the gateway address.
To assign the gateway address manually, select Address Mode "Static".
This address identifies the router on the same network as the instrument that is used to
forward traffic to destinations beyond the local network.
Remote command:
:SYSTem:COMMunicate:NETWork[:IPADdress]:GATeway on page 353
DNS Suffix
Displays the primary DNS (Domain Name System) suffix, that means the DNS name
without the host name part.
The DNS system uses the suffix for registration and name resolution to uniquely iden-
tify the instrument in the entire network.
To assign the DNS suffix manually, select Address Mode "Static".
Remote command:
:SYSTem:COMMunicate:NETWork[:COMMon]:DOMain on page 352
DNS Server
Determines the preferred server for name resolution. The DNS server contains the
underlying numerical values that are required for name resolution of the host name as
part of the IP address.
To select the DNS server manually, select Address Mode "Static".
Remote command:
:SYSTem:COMMunicate:NETWork[:IPADdress]:DNS on page 353
MAC Address
Indicates the MAC (Media Access Control) address, a unique identifier of the network
adapter in the R&S SMC.
Remote command:
:SYSTem:COMMunicate:NETWork:MACaddress on page 354
Restart Network
Terminates the network connection to the instrument and subsequently re-establishes
it.
Used this function to resolve network problems.
General Instrument Settings