Rohde & Schwarz SMC100A - Page 282

Remote Control Commands
R&S
®
SMC100A
267Operating Manual 1411.4060.32 ─ 09
:OUTPut<hw>:PROTection:TRIPped?
Queries the state of the protective circuit.
Return values:
<Tripped> 0 | 1 | OFF | ON
*RST: 0
Example:
OUTP:PROT:TRIP
Queries the state of the protective circuit for RF output A.
Response: 0
The protective circuit has not tripped.
Response: 1
The protective circuit has tripped.
Usage: Query only
Manual operation: See " Overload " on page 147
:OUTPut<hw>[:STATe]
<State>
Activates and deactivates the RF output signal (RF ON / RF OFF).
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example:
OUTP OFF
deactivates the RF output.
Manual operation: See "RF On" on page 120
:OUTPut<hw>[:STATe]:PON <Pon>
Selects the state of the RF output when the instrument is switched on.
Parameters:
<Pon> OFF | UNCHanged
OFF
deactivates the output when the instrument is switched on (RF
OFF).
UNCHanged
restores the initial state of the RF output before the last turn off.
sets the output status as it was when the instrument was
switched off.
*RST: UNCHanged
Example:
OUTP:PON OFF
RF output A is deactivated when the instrument is switched on.
Manual operation: See " Power-On State - RF Signal " on page 133
OUTPut Subsystem