LIST Mode SME
1038.6002.02 2.146 E-13
RESET LIST Ð
Sets the starting point.
IEC-bus short command :ABOR:LIST
DWELL
Input value of the dwell time per step.
IEC-bus short command :SOUR:LIST:DWEL 10ms
CURRENT INDEX
Indication of the current list index. Setting value of the current list index in the
STEP operating mode.
LEARN Ð
Starts the LEARN function. All value pairs of the active list are subsequently
set by the instrument with the current additional parameters, and the hardware
setting data are stored.
Caution: This function must be called after every creating and altering the
list (or the remaining setting data).
IEC-bus short command :SOUR:LIST:LEAR
SELECT LIST...
Selection of a list or creation of a new list (cf. Section 2.2.4, List Editor).
IEC-bus short command :SOUR:LIST:SEL "LIST2"
DELETE LIST...
Deletion of a list (cf. Section 2.2.4, List Editor).
IEC-bus short command :SOUR:LIST:DEL "LIST1"
FUNCTION
Selection of the editor functions to process a list (cf. Section 2.2.4, List Editor).
IEC-bus short command
:SOUR
:LIST:FREQ 100MHz, 1.2GHz; POW 0dBm, 6dBm
To Next Page
Loading...
