SME SOURce:FLEX
1038.6002.02 3.59 E-133
[:SOURce]:FLEX:MESSage:ALPHanumeric[:SELect] "FOX" | "ALPHA" | "USER1" | "USER2" |
"USER3" | "USER4"
This node contains commands for the determination of the contents of the alphanumeric and the
secured messages. There is one common character set for the two types of messages. These
commands can only be activated if FLEX:MESSage:CATegory ALPHanumeric or SECure is
selected.:
"FOX" The quick brown fox jumps over the lazy dog
"ALPHA" ABCD to (complete FLEX character set)
"USER1 to 4" Four messages that can be freely edited by command ALPHanumeric:DATA.
Example: :SOUR:FLEX:MESS:ALPH:SEL "FOX" *RST value is USER3
[:SOURce]:FLEX:MESSage:ALPHanumeric:CATalog?
The command queries the alphanumeric and secured alphanumeric messages available. It
causes a list to be returned on which the entries are separated by commas. The command is a
query command and thus has no *RST value.
Example: :SOUR:FLEX:MESS:ALPH:CAT? Answer: FOX, ALPHA, USER1
[:SOURce]:FLEX:MESSage:ALPHanumeric:DATA "String"
The command allows any character string to be entered into one of the alphanumeric messages
USER 1 to 4. This message has to be selected first with the command ALPHanumeric:SELect.
*RST value is "" (eg, empty message)
Example: :SOUR:FLEX:MESS:ALPH:DATA "Hallo"
[:SOURce]:FLEX:MESSage:BINary
This node contains commands for the determination of the contents of the binary messages. The
commands can only be activated if FLEX:MESSage:CATegory BINary is selected.
[:SOURce]:FLEX:MESSage:BINary[:SELect] "USER1" | "USER2"
The command selects the binary messages. *RST value is USER1
Example: :SOUR:FLEX:MESS:BIN:SEL "USER1"
[:SOURce]:FLEX:MESSage:BINary:BLENgth 1 to 16
The command sets the number of bits to be interpreted as a unit (character). This value has no
significance for SME. It is transmitted to the pager and evaluated there. *RST value is 1
Example: :SOUR:FLEX:MESS:BIN:BLEN 16
[:SOURce]:FLEX:MESSage:BINary:CATalog?
The command queries the binary messages available. It causes a list to be returned on which the
entries are separated by commas. The command is a query command and thus has no *RST
value.
Example: :SOUR:FLEX:MESS:BIN:CAT? Answer: USER1
[:SOURce]:FLEX:MESSage:BINary:DATA "0 | 1 [,0 | 1]"
The command allows the entry of any binary data into one of the binary messages. Values 0 and 1
are available. Each value represents 1 bit. The maximum length of the message is 460 bit.This
message has to be selected first with the command BINary:SELect.
Example: :SOUR:FLEX:MESS:BIN:DATA "111101" *RST value is "" (i.e., empty message)
To Next Page
Loading...
