SOURce:FLEX SME
1038.6002.02 3.60 E-13
[:SOURce]:FLEX:MESSage:BINary:DDIRection LEFT | RIGHt
The command determines the direction of binary messages.
LEFT Display from left to right.
RIGHtDisplay from right to left. *RST value is LEFT
Example: :SOUR:FLEX:MESS:BIN:TYPE LEFT
[:SOURce]:FLEX:MESSage:MNUMbering ON | OFF
The command determines whether every message is to be assigned with a number and whether
this information is to be evaluated when received by the pager.
ON SME sends the number 0 for every message.
OFF No number is sent.
Example: :SOUR:FLEX:MESS:MNUM OFF *RST value is OFF
[:SOURce]:FLEX:MESSage:MDRop ON | OFF
The command determines whether or not the messages are to be marked with a MAIL-DROP flag
(see chapter 2, section "Radiocommunication Service FLEX").
ON The messages are marked as "volatile".
OFF The messages are not marked.
Example: :SOUR:FLEX:MESS:MDR OFF *RST value is OFF
[:SOURce]:FLEX:MESSage:NUMeric "String"
The command determines the type of character string the numeric message may consist of. SME
allows a maximum of 41 characters. In addition to the 10 figures "0" to "9" other characters such
as square brackets right and left "[", "]", upper case letter "U", hyphen "-" and blank space " " can
be used. This command can only be activated if FLEX:MESSage:CATegory NUMeric is
selected. *RST value is "0123456789 U-[]"
Example: :SOUR:FLEX:MESS:NUM "15-17"
[:SOURce]:FLEX:MESSage:REPeats 0 to 3
The command determines the number of calls following the first call according to FLEX-TD. For
the value 0 (no repeat), normal flex frames are transmitted, whereas subframes according to
FLEX-TD are used with other values (cf. Section 2.6.3.12, Radiocommunication Service FLEX).
Example: :SOUR:FLEX:MESS:REP 0 *RST value is 0
[:SOURce]:FLEX:MESSage:TONE 0 to 7
The command determines which of the 8 possible tones is to be transmitted in case of an
only-tone message. This command can only be activated if FLEX:MESSage:CATegory TONE is
selected.
Example: :SOUR:FLEX:MESS:TONE 7 *RST value is 0
To Next Page
Loading...
