Roland SH-4d - Page 169

PATTERN CHORUS
169
TimeCtrlDly (Time Control Delay)
This is a delay in which the delay time can be varied smoothly.
Parameter
Value
Explanation
Dly Sync
OFF, ON
If this is ON, the delay synchronizes with the tempo.
Dly Msec
1–1300
Adjusts the delay time from the direct sound until the delay sound is heard.
Dly Note
Note
Acceleration
0–15
When you change the delay time, this specifies the time over which the current delay time
changes to the specified delay time. This affects the speed of pitch change as well as the delay
time.
Feedback
-98–+98 [%]
Adjusts the proportion of the delay sound that is fed back into the effect. Negative (-) settings
will invert the phase.
HF Damp
200–8000 [Hz],
BYPASS (*1)
Adjusts the frequency above which sound fed back to the effect is filtered out. If you don’t want
to filter out any high frequencies, set this parameter to BYPASS.
Delay Ó Trem (delay Ó tremolo)
Tremolo is applied to the delay sound.
Parameter
Value
Explanation
Input
MONAURAL
The input is mono-mixed.
STEREO
The sound is input in stereo.
Dly Sync
OFF, ON
If this is ON, the delay synchronizes with the tempo.
Dly Msec
1–1300
Adjusts the delay time from the direct sound until the delay sound is heard.
Dly Note
Note
Feedback
-98–+98 [%]
Adjusts the proportion of the delay sound that is fed back into the effect. Negative (-)
settings will invert the phase.
HF Damp
200–8000 [Hz],
BYPASS (*1)
Adjusts the frequency above which sound fed back to the effect is filtered out. If you don’t
want to filter out any high frequencies, set this parameter to BYPASS.
Trm Switch
OFF, ON
Switches the tremolo effect on/off
Trm
ModWave
This sets how the panning changes.
TRI
Triangle wave
SQR
Square wave
SIN
Sine wave
SAW1
Sawtooth wave
SAW2
TRP
Trapezoidal wave
Trm Sync
OFF, ON
If this is on, the tremolo synchronizes with the tempo.
Trm Hz
0.05–10.00 [Hz]
Adjusts the rate of the tremolo.
Trm Note
Note
Trm Depth
0–127
Adjusts the depth of the tremolo.
2Tap PanDly (2Tap Pan Delay)
Delay sound is heard in the two locations you specify.
Parameter
Value
Explanation
Dly Sync
OFF, ON
If this is ON, the delay synchronizes with the tempo.
Dly Msec
1–1300
Adjusts the time until the second delay sound is heard.
Dly Note
Note
Feedback
-98–+98 [%]
Adjusts the proportion of the delay sound that is fed back into the effect. Negative (-) settings
will invert the phase.
HF Damp
200–8000 [Hz],
BYPASS (*1)
Adjusts the frequency above which sound fed back to the effect is filtered out. If you don’t want
to filter out any high frequencies, set this parameter to BYPASS.
Dly1 Pan
L64–63R
Adjusts the pan position of Delay 1.
Dly2 Pan
L64–63R
Adjusts the pan position of Delay 2.
Dly1 Level
0–127
Adjusts the volume of Delay 1.
Dly2 Level
0–127
Adjusts the volume of Delay 2.