Assembly and installation | 5
VERSION 1 | EN-US CIRUS
®
UPT-6400 Page 19 of 104
5 Assembly and installation
5.1 Transporting and checking device
To prevent damage, always transport and store the device in the original box.
After transporting the device, visually inspect the device for any damage.
5.2 Scope of delivery
Check the delivery for damage and verify that it is complete.
Delivery includes:
• Temperature controller with terminal strips in place.
5.3 Installation site requirements
Installation site
NOTICE
Liquids and dust can damage the equipment
Liquids and dust that penetrate the device can impair proper functioning. Electrical
components can become corroded.
Set up and operate the device only in a clean, dust-free environment.
Protect the device from moisture, water, cleaning solutions and conductive liquids.
Ensure that the area is well ventilated.
The installation site must be dry and frost-free at all times.
Machine-side supply
voltage
NOTICE
Equipment damage caused by incorrect supply voltage
Supply voltage that is too high or too low can damage the device.
Adjust the machine-side supply voltage to suit the permitted voltage and frequency
range of the temperature controller.
Observe the information on the ID plate.
5.4 Device assembly
DANGER
Risk of death by electric shock
There is dangerous voltage at the electrical connections to the temperature controller,
the system components and the heat-sealing bar.
Electrical installation may be performed only by qualified electricians.
Switch off the voltage supply or line voltage.
Secure to prevent it from being switched on again.
Verify that there is no voltage being supplied.
To Next Page