Ropex CIRUS UPT-6400 - Basic Functions; Setting Language

8 | Functions and settings
Page 52 of 104 CIRUS
®
UPT-6400 VERSION 1 | EN-US
Menu Menu number Menu item Setting
Information 602 Cycle counter (cali-
bration channel)
For all channels: 0
603 Date and time
604 ID plate
605 Protocol entries
The parameters saved in the recipes contain the same standard values as the respec-
tive single parameters.
Proceed as follows to reset the temperature controller to the defaults:
1. Select the Operation menu, menu number202.
2. Press Enter.
3. Press Enter again to confirm the security prompt.
ð The confirmation appears on the screen for 2 sec.
8.1.4.1 Resetting to defaults
Preventing
malfunctions
If the temperature controller settings are not known upon initial startup, reset the tem-
perature controller to the defaults to prevent malfunctions.
Resetting to defaults
Reset the internal temperature controller settings in the Operation menu, menu
number202. The language setting in the Operation menu, menu number201 is the
only setting that is not changed by resetting to the defaults.
For more information on the defaults, refer to Werkseinstellung.
8.2 Basic functions
8.2.1 Setting language
Select the language in which the menus should appear in the Operation menu,
menu number201.
The following languages are available:
• German
• English
• Italian
• French
• Italian
• Dutch
• Spanish
• Swedish
• Polish
• Portuguese
• Finnish
• Danish
• Turkish
• Greek
The language can be changed during operation.
The language remains unchanged if the temperature controller is reset to the default.