Ropex CIRUS UPT-6400 - Menu Navigation Without Alarm

Functions and settings | 8
VERSION 1 | EN-US CIRUS
®
UPT-6400 Page 47 of 104
Menu
num-
ber
Menu
item
Available
only
when the
timer is
activated
(menu
number
401)
Description Setting range
605 Display
of proto-
col en-
tries
The following events are entered into the protocol:
• Alarms
• Execution of AUTOCAL and MASTER-AUTOCAL
• Time and date settings
• Loading and saving of recipes
• Firmware update
When the log memory is full, the oldest protocol entry is
overwritten.
Navigate through the protocol entries by pressing Up and
Down.
Protocol entry1 always shows the most recent event.
8.1.2 Menu navigation without alarm
Proceed as follows to navigate through the various menu items and levels:
1. Press Menu briefly (< 1sec)
ð to move to the next menu item.
2. Press Menu for longer than 2sec.
ð The system then returns to the standard display, except when there is a tem-
perature controller alarm. In this case, the systems jumps back to the alarm
menu.
If the display shows the standard screen or an alarm, proceed as follows to move to
the configuration level:
 Press Menu for longer than 2sec.
ð The temperature controller changes to the configuration level.
If Menu is pressed for 1-2 sec, the system returns to the previous menu item.