Ropex CIRUS UPT-6400 - Page 42

8 | Functions and settings
Page 42 of 104 CIRUS
®
UPT-6400 VERSION 1 | EN-US
Menu
num-
ber
Menu
item
Available
only
when the
timer is
activated
(menu
number
401)
Description Setting range
408 Relay K2 Configure how relay K2 (terminals 22, 23, 24) switches
on.
Refer to section Outputs relay K1, relay K2 and outputA1
for further information.
Without timer:
• Active when Tact
=Tset
• Active when Tact
= Tset, with latch
• Active during AU-
TOCAL
• Active when
there is an alarm
(The configura-
tion of switching
in menu number
405 also applies
to relay K2)
• ON
• OFF
Additionally when
timer is active:
• Active with
START signal
• Active when tem-
perature reached
• Active during
cooling phase
• Generates end of
cycle pulse
• Active during
heating phase
• Active with exter-
nal switch
• Active with exter-
nal switch or start
signal