Rotax 125 Micro MAX - Carburetor and Intake Silencer Removal Safety; Removing Carburetor and Intake Silencer

DK00028.fm
REPAIR MANUAL
BRP-Powertrain
Effectivity: 125 MAX/125 Junior MAX/125 Mini
MAX/125 Micro MAX
Edition 2 / Rev. 0
Chapter 6
Page 5
December 01/2010
2) Removal of carburetor and intake silencer
Safety
instructions
Preparation The following preparation is required before removal:
2.1) Removal of carburetor and intake silencer
Instructions See Figure 2.
Proceed as follows to remove the carburetor and intake silencer:

WARNING

WARNING
Danger of explosion and ignition!
Overflowing and split gasoline must be absorbed im-
mediately with a binding agent and correctly disposed
of. Do not work with open flames and sources of igni-
tion. Fuel must not be allowed to come into contact
with hot engine parts and components.
Step Procedure
1 Pull off fuel line between fuel tank and fuel pump from the fuel pump and seal
it.
2 Remove the bowden cable. See also Chap. 3).

WARNING
NOTICE
Fuel may spill out when removing the carburetor.
Step Procedure
1 Pull of fuel line between the fuel pump and carburetor from the carburetor.
2 Pull off the impulse pipe (1) from the impulse connector.
3 Unscrew 3 cyl. screws on the carburetor port (2).
4
Remove carburetor (3) with intake silencer (4) with support bracket (5) and fuel
pump (6).