DK00024.fm
REPAIR MANUAL
BRP-Powertrain
Effectivity: 125 MAX/125 Junior MAX/125 Mini
MAX/125 Micro MAX
Edition 2 / Rev. 0
Chapter 2
Page 5
December 01/2010
1.3) Procedure notes
Safety note
Ignition “OFF“
Handling of oper-
ating fluids
At maintenance of cooling-, lubricating and fuel system take care without
fail that no contamination, metal chips, foreign material and/or dirt enters
the system.
Disassembly At disassembly of the engine, mark the components as necessary to
avoid any mix-up. Take care of these marks, don‘t ruin them.
Tool
Safety wiring
Cleaning of parts
Non-compliance can result in serious injuries or
death!
When carrying out maintenance and service work, re-
spect without fail the safety regulations.
Non-compliance can result in serious injuries or
death!
This precautionary measure serves to avoid any inju-
ries in case of an unintentional start of the engine.
Principally ensure the following at each maintenance
event
- Ignition “OFF“ and system grounded,
- Disconnect battery
and secure engine against unintentional operation.
Failure to comply with this instruction may cause se-
vere burns or scalding!
Hot engine parts!
Allways allow the engine to cool down to ambient tem-
perature before starting work.
In order to avoid mechanical damages, never loosen
or tighten screws and nuts with pliers but only with the
specified tools.
If during diassembling/reassembling the removal of a
safety item (e.g. safety wiring, self-locking fastener,
etc.) should be necessary, it must be always replaced
by a new one.
All metall and synthetic parts are generally washed
with suitable cleaning agents. Before using new and
unknown cleaning agents check the compatibility of
materials.
To Next Page
Loading...
Need help?
General
