DK00024.fm
REPAIR MANUAL
BRP-Powertrain
Effectivity: 125 MAX/125 Junior MAX/125 Mini
MAX/125 Micro MAX
Edition 2 / Rev. 0
Chapter 2
Page 6
December 01/2010
Removed parts
Before re-using disassembled parts, clean, check and refit them as per
instructions.
Use clean screws and nuts only and inspect face of nuts and thread for
damage. Check the contact faces and threads for damages. In case of
doubt, use new screws and nuts.
Measurements When making low tolerance measurements (s<0.1 mm) and in measuring
bearing and housing components, the temperature of the components and
their surroundings must be in the range 20 °C-25 °C.
Nuts Once loosened, always replace self-securing nuts!
Sealing rings,
O-rings
At reassembly of the engine, replace all sealing rings, gaskets, securing
elements, O-rings and oil seals.
Re-assembly Before re-assembly check components whether parts are missing. Only
use adhesives, lubricants, cleaning agents and solvents indicated in the
maintenance instructions. If not respected, damage may be the conse-
quence.
To Next Page
Loading...
