Sam4s ER-260EJ - Add;Change PLU Entries

112 • Program Mode Programming Sam4s ER-260EJ/256EJ OP Manual v1.20
Add/Change PLU
Add/Change One PLU
1. From the PLU PROGRAMMING screen, use the CHARGE1 and the
CHARGE2 keys to select “1.ADD/CHANGE” (or press 1 to go to the option
directly). Press CASH to view the add or change a PLU screen:
ADD/CHANGE
1.ONE PLU
2. From the ADD/CHANGE screen use the CHARGE1 and the CHARGE2 keys to
select “1.ONE PLU” (or press 1 to go to the option directly). Press CASH to view
PLU NUMBER screen:
ENTER PLU #
0
3. Enter PLU number and CASH to select individual PLU. The PLU OPTION screen
displays:
4. Refer to "PLU Options - Reference Information" on page 113 to make program
entries or changes, press the CLEAR key to finalize and return to the previous
screen.
Add/Change Range of PLU’s
1. From the PLU PROGRAMMING screen, use the CHARGE1 and the
CHARGE2 keys to select “1.ADD/CHANGE” ” (or press 1 to go to the option
directly). Press CASH to view the add or change a PLU screen:
2. From the ADD/CHANGE screen use the CHARGE1 and the CHARGE2 keys to
select “2.RANGE PLU” (or press 2 to go to the option directly). Press CASH to
enter the beginning number in the PLU range you wish to program:
ENTER FROM PLU #
0
3. Enter the FROM PLU number and CASH to display TO PLU# screen:
ENTER TO PLU#
0
4. Enter the TO PLU number and CASH to display PLU OPTIONS.
5. Refer to "PLU Options - Reference Information" on page 113" to make program
entries or changes, press the CLEAR key to finalize and return to the previous
screen.