182 • Integrated Payment Appendix Sam4s ER-260EJ/256EJ OP Manual v1.20
Integrated Payment Appendix
Introduction
This guide supports integrated payment applications utilizing EMV enabled Datacap equipment for
the SAM4s ER-260EJ/ER-265EJ ECRs. To implement the EMV application, the following is
required:
1. For installation that will be using integrated payment, an SD card must be placed in the
SD card slot on the right side of the ECR. (The card is used to store transaction records
so they can easily be called up by invoice number for tip adjustment and/or voiding.)
2. Deploy your application with the latest EMV capable Datatran equipment, using either
the IPTran LT or the Tran Server with PDC’s. (Refer to the configuration diagrams that
follow. It is more cost-effective to use the Tran server and PDC configuration when your
network includes four or more ER-260EJ/ER-265EJ ECRs.)
3. For PIN-Pad/EMV reader, check with your provider for compatible devices.
4. When your configuration is completed and connected to an active Ethernet line, perform
the “Dial In Load” as shown on page 208 and then perform the “Parameter Download” as
described on page 206.
What to Order?
Datatran Equipment Part Numbers
1900.20 – IPTran™ LT (applications with up to 3 ECRs)
1715.20 – New Style PDC (applications with 4 or more ECRs)
1900.50 – Tran Server (applications with 4 or more ECRs)
7871.01 – Serial Interface Cable DB9-M connection (Included)
7877.30 – Peripheral Adapter Cable (For PIN-Pad connection)
PIN-Pad
For EMV Installations, use a Pin-Pad recommended & approved by your provider. For example: the
Verifone Vx805 may be used with the certified version of XPI (8.42B).
VeriFone Part Numbers:
M280-703-A3-WWA-3 –VeriFone Vx805
PWR282-001-01-A – Power Cable
CBL282-031-02-A – Serial Interface Cable
Load XPI Application (Version 8.42B)
Processor Encryption (Specific to merchant installation)
To Next Page
Loading...
