192 • Integrated Payment Appendix Sam4s ER-260EJ/256EJ OP Manual v1.20
Load the EMV Parameters
After connecting the new EMV compatible Datatran device and PIN-Pad to the ECR and all the
required programming is completed, you must load the parameters for the devices. The IPTran LT
must be connected to the internet to load the parameters.
1. To load the Datatran device parameters perform the “Dial In Load” procedure as
explained on page 208 in this guide.
2. To load the PIN-Pad parameters perform the “Parameter Download” as explained on
page 206 in this guide.
Integrated Payment/EMV Functions
Sample Transaction
Close the previous day’s batch before beginning a new sales day. A new batch is opened
automatically when the previous batch is closed.
1. Register a normal transaction.
2. Press the appropriate CHARGE key. The message “WAITING FOR EFT” displays.
3. At the PIN-Pad the message displays:
SALE
$2.00 – OK?
4. Press the GREEN button on the PIN-Pad keypad.
5. Insert the EMV card into the PIN-Pad. The PIN-Pad will display “PLEASE WAIT”, then
“DO NOT REMOVE CARD”, and then “PROCESSING”. When Complete, the
“APPROVED” message will display.
6. Remove the card from the PIN-Pad.
7. At the register, the message “PRESS CASH TO CONTINUE” will display.
8. Press CASH. The receipt and card draft are printed.
9. If multiple documents are to be printed, the message “PRESS CASH TO CONTINUE”
displays. Tear off the printer paper, and press CASH to resume printing.
To Next Page
Loading...
