Sam4s ER-260EJ - ECR Setup Configurations

Sam4s ER-260EJ/256EJ OP Manual v1.20 Service Mode Programming • 93
ECR Setup
1. Move the key to the S lock position to display the Service Mode menu.
2. From the Service Mode menu press CHARGE1 until “ECR SETUP” is selected
(or press 6 to view the option directly.)
3. Press CASH. The ECR SETUP menu displays:
ECR SETUP
1.ROM INFO
4. Four options are available: 1.ROM INFO, 2.PRINT DENSITY, 3.LCD CONTRAST,
and 4.SET NETWORK.
5. Use CHARGE1and the CHARGE2 keys to scroll up and down through the ECR
SETUP menu.
6. Select an option and press CASH to initiate.
7. Press CLEAR to exit the program.
ROM INFO
This selection displays the version, check sum and date of the Flash ROM. You may be asked to
check your Flash ROM version if you contact your dealer for assistance. Press CASH to print the
version information.
Print Density
Three levels of density are available. Press the CHARGE1and the CHARGE2 keys to select the
next level. The printer will print a sample.
LCD Contrast
Press the CHARGE1and the CHARGE2 keys to select a contrast value from 0 (dim) to 15
(brightest). The front and rear displays will adjust simultaneously.
Set Network
Use DHCP, ECR IP, ECR SUBNET, ECR GATEWAY, Server IP, Server PORT, ETHERNET USE.