Sam4s ER-260EJ - Group Programming Guide

Sam4s ER-260EJ/256EJ OP Manual v1.20 Program Mode Programming • 119
Group Programming
Up to 99 groups (the exact number is determined by memory allocation) are available to summarize
PLU sales. Group totals appear on reports, so that you can track sales of different types of items.
 The group descriptors programmed here will replace the default descriptors GROUP 1
through GROUP 99 that appear on reports.
 Each PLU can report totals to one, two or three different groups. If a PLU sends totals to
more than one group, the group total that appears on the Group report will not represent
PLU sales. Therefore, you also have the option of deciding whether each group's total
will add to the group total on the Group report.
To Program Groups
1. Move the key to the P lock position to display the Program Mode menu.
2. Press the CHARGE1 to select “2.GROUP” (or press 2 to the option directly).
3. Press CASH to display the GROUP PROGRAMMING screen. (The maximum
number of groups is determined by memory allocation.)
ENTER GROUP #
(1-10) 0
4. Enter the number of the group to be programmed, press the CASH. The GROUP#
PROGRAMMING screen displays:
GROUP
1.DESC : [GROUP
5. There are nine group options that can be set:
1.DESC [GROUP 01]
2.ADD TO GROUP TO GROUP
TOTAL
3.SEND TO KP
4.KP PORT#: RCPT
5.KP PORT#: 1
6.KP PORT#: 2
7.KP PORT#: 3
8.PRINT RED ON KP
9.GIFT CARD
6. Use the CHARGE1 and the CHARGE2 keys to scroll up and down through the
options. Or, if you already know the menu number of the option you with to
perform, you can enter the digit (1-9) directly. Press the CASH key.
7. Use the “Group Programming - Reference Information” on the following page and
make changes as necessary. Press CLEAR to return to the PROGRAM MODE
screen.