Sam4s ER-260EJ - CURRENCY CONVERSION 1-4 Key Function Options; ERROR CORRECT Key Function Options

Sam4s ER-260EJ/256EJ OP Manual v1.20 Program Mode Programming • 131
CURRENCY CONVERSION 1-4 Key Function Options
Currency Exchange Rate Programming Examples
Note: Foreign currency exchange rates can be stated as “foreign currency in dollars”, or
“dollars in foreign currency”. Use the rate stated in “dollars in foreign currency” when you are
programming this section.
The US dollar (home currency) is worth 1.2764 Canadian dollars (foreign currency).
RATE: 12764 NUMBER OF DEC.: 4
The US dollar (home currency) is worth 110.24 Japanese Yen (foreign currency).
RATE: 107565 NUMBER OF DEC.: 2
Currency Conversion 1-4 Program Notes
Option Entry Description
1 DESC
Alpha
numeric
24 character
You can program a unique descriptor for each foreign
currency. The default descriptors are CONV 1-4.
2 EXCHANGE RATE 7 digits
Enter the exchange rate of up to 7 digits (do not enter the
decimal point). See the examples.
3 DECIMAL PLACE 0 - 4
Enter a number from 0 to 4 to indicate the decimal position
of the exchange rate. Count the decimal position from the
right. See the examples below.
ERROR CORRECT Key Function Options
Option Entry Description
1 DESC
Alpha
numeric
24 character
You can program a unique descriptor. The default descriptor
is ERRCORR.
2 HALO
7-digit
amount
You can limit errors by setting the maximum amount that can
be used with this function. "0" means that there is no entry
limit.
3 KEY DISABLE Y or N Select Y to disable this function.
4
UNDER
MANAGER
CONTROL
Y or N
Select Y if you do not want the operator to use this function
in REGISTER MODE. When selected, the function is
allowed only in the MANAGER MODE.
5
COMPULSORY
VALIDATION
Y or N
Choose Y to enforce validation if an optional printer with
validation capability is connected to a Serial port.