130 • Program Mode Programming Sam4s ER-260EJ/256EJ OP Manual v1.20
CHECK ENDORSEMENT Key Function Options
Option Entry Description
1 DESC
Alpha
numeric
24 character
You can program a unique descriptor. The default descriptor
is CHKENDOR.
2 KEY DISABLE Y or N Select Y to disable this function.
3
UNDER
MANAGER
CONTROL
Y or N
Select Y if you do not want to allow the operator use of this
function in REGISTER MODE. When selected, the
function is allowed only in the MANAGER MODE.
4
PRINT CHECK
AMT IN THE
ENDORSEMENT
Y or N
Choose Y to print the amount of check as well as the
endorsement message. Choose N to print only the
endorsement message.
Note: A 10-line check endorsement message may be
programmed. See "Endorsement" on page 164 for more
information.
5 PRINT DATE Y or N Select N to suppress printing Date on the check endorsement.
6 PRINT TIME Y or N Select N to suppress printing Time on the check endorsement.
7 PRINT CLERK Y or N
Select N to suppress printing the Clerk name on the check
endorsement.
8
PRINT
CONSECUTIVE
No
Y or N
Select N to suppress printing the Consecutive number on the
check endorsement.
9
SLIP OUTPUT
PORT#(0-2)
0-3
If validation is used, identify the communications port (1 or
3) where the validating printer is attached. Enter 0 if
validation is not used.
To Next Page
Loading...
