Sam4s ER-260EJ - PLU Stock Management

Sam4s ER-260EJ/256EJ OP Manual v1.20 Program Mode Programming • 117
PLU Stock
Note: Before program PLU stock, ‘Inventory Item’ option set as ‘Y’ in PLU programming.
1. From the PLU PROGRAMMING screen, select “3.PLU STOCK” (or press 3 to go to
the option directly). Press CASH to view the PLU Stock screen:
PLU STOCK
1.ONE
2. Select the PLU or PLU’s you wish to program one of the following ways.
One PLU
3. From the PLU STOCK screen, select “1.ONE” (or press 1 to go to the option
directly). Press CASH to view the PLU NUMBER screen:
ENTER PLU #
0
Range of PLU’s
4. From the PROGRAM screen select “2.RANGE PLU” (or press 2 to go to the option
directly). Press CASH to display RANGE PLU screen.
ENTER FROM PLU #
0
5. Enter FROM PLU# number and CASH to display TO PLU# screen:
ENTER FROM PLU#
1
ENTER TO PLU #
20
6. Enter TO PLU# number and CASH to display STOCK ENTRY screen:
OPERATOR: ADD(+)
ADD(+)
7. Select operator ADD (+), SUB (-) or REPLACE.
8. Enter the stock quantity you wish to ADD/SUBTRACT/REPLACE, and press
CASH. Note that stock is kept in decimal units and you must enter new or additional
stock to two digits beyond the decimal. For example: type 1 0 0 0 to enter ten units
of inventory.
9. To program additional PLU’s repeat from step 3, or press CLEAR key to finalize.