94 • Service Mode Programming Sam4s ER-260EJ/256EJ OP Manual v1.20
Program Backup
USB and SD utilities in this program include:
Program Backup & Restore
Report Save
Pre-Image Logo Loading & Save
Post-Image Logo Loading & Save
Flash ROM update can also be done by SD card or through a serial connection to a PC.
The SD slot is located on the right-hand side. See page 14 for detail.
The USB port must be assigned the “Memory” function to be used for backup
utilities. See “USB Setting" on page 92.
Program Backup General Instructions
1. Move the key to the S lock position to display the Service Mode menu.
2. From the Service Mode menu press CHARGE1 until “PROGRAM BACKUP” is
selected (or press 7 to view the option directly.)
3. Press CASH. The PROGRAM BACKUP menu displays:
PROGRAM BACKUP
1.SD
4. Use CHARGE1and the CHARGE2 keys to select SD or USB (or press 1 or 2 to
select the memory device.) Press CASH to display the menu:
SD
1.PGM BACKUP
5. The following functions are available:
1.PGM BACKUP
2.PGM RESTORE
3.REPORT SAVE
4.IMAGE SAVE
5.IMAGE LOAD
6.BOOT UP SD (AVAILABLE ON SD ONLY)
7.BOOT UP COM (AVAILABLE ON SD ONLY)
6. Insert the SD card in the register’s SD slot or insert a USB memory stick in the USB
port on the connection panel.
7. Use the CHARGE1 and the CHARGE2 keys to scroll up and down through the
menu. Or, if you already know the menu number of the Program Backup function
you with to perform, you can enter the digit (1-7) directly.
8. Press CASH. Read the specific notes for each function that follow.
To Next Page
Loading...
