98 • Service Mode Programming Sam4s ER-260EJ/256EJ OP Manual v1.20
Load/Save Receipt Images
You can load a preamble and postamble image on your receipt. Before loading, the images must be
converted by the PC Utility to “.img” format. After conversion, they can be loaded directly by
connecting a PC to the ER-260EJ/ER-265EJ or by copying the images to a SD card and loading (or
saving the image) using the SD utility program described here.
Note: after loading the images, you must set “LOGO (Print preamble image / Print postamble
image)” of the “Options Programming” in the “Program Mode Programming” to activate the
image printing.
Use the SAM4s PC Utility (eSpresso) to Convert the Image
1. Install the eSpresso on your PC and run it.
2. If you start the eSpresso for the first time, you must define the store and register, or if the
store and register is already defined, you can select the store from the register list. The
eSpresso program starts.
3. At the eSpresso, choose Image Logo from the Edit Program menu.
4. Click the FILE OPEN ( ) button. Select the image file that you wish to use from the
Open dialog and click the Open command button.
5. You can view the original and the converted image of a selected image.
6. You can change the properties of the image. (Sharpness and Brightness)
7. You can select the PREAMBLE IMAGE or POSTAMBLE IMAGE.
8. Click the DOWN ( ) button. “Download completed” message is displayed.
If you want to save the converted image, Click the SAVE ( ) button. (Saved images are
stored in My Documents folder.)
To Next Page
Loading...
