Sam4s ER-260EJ - Page 76

76 • Manager Mode (X Mode) Sam4s ER-260EJ/256EJ OP Manual v1.20
9. Enter the beginning number in the range of PLU’s you wish to program and then
press CASH.
ENTER TO PLU #
0
10. Enter the ending number in the range of PLU’s you wish to program and then press
CASH.
11. The selection menu displays to select ADD, SUB or REPLACE. Note that stock is
kept in decimal units and you must enter new or additional stock to two digits
beyond the decimal. For example: type 1 0 0 0 to enter ten units of inventory.
OPERATOR: ADD(+)
ADD(+) ←
12. With “ADD (+)” displayed, press CASH to enter the number of units you wish to
add to the existing inventory count, or press CHARGE1 to select subtract:
OPERATOR: ADD (+)
SUB(-) ←
13. With “SUB (-)” displayed, press CASH to enter the number of units you wish to
subtract from the existing inventory count, or press CHARGE1 to select replace.
OPERATOR: ADD (+)
REPLACE ←
14. With “SUB (-)” displayed, press CASH to enter the number of units you wish to use
as the new inventory count
15. After entering the ADD, SUBTRACT or REPLACE value, press CASH.
16. To program additional PLU’s repeat from step 4, or press CLEAR key to exit the
program.