Sam4s ER-260EJ - Page 86

86 • Service Mode Programming Sam4s ER-260EJ/256EJ OP Manual v1.20
Self-Test Operations
Operation Selection
Description
1. Batch Test
Runs a series of hardware tests; Some tests require
additional equipment or inputs from operator.
2. Printer 1. Print Test Prints the printer test pattern.
2. Reverse Image Prints a test receipt image in reverse.
3. Endless Print
Prints a test transaction continuously, press clear to exit the
test.
4. Barcode Test Prints a Test Barcode.
5. Make Barcode Print a barcode for numeric entry up to 13 digits.
3. Display 1. LCD Test Runs the LCD Tests.
2. Contrast Test Performs the Contrast Test.
4. Keyboard 1. Keyboard Test Allows keyboard test – press desired keys to test.
2. Mode Key Test Mode test – tune mode key to VOID and back to S-Mode.
5. Interface 1. Port 1
Port tests require a Loop-Back connector be attached to the
port for testing.
2. Port 2
3. Port 3
4. Drawer
Press CASH to Kick the drawer, close the drawer to repeat
test; press CLEAR to exit the test.
5. USB Host Insert USB drive to run test.
6. External SD Insert SD Card to run test.
7. Micro SD Insert Micro SD to run test.
8. Ethernet Requires Ethernet connection to run test.
6. RTC 1. RTC Set Set Date & Time
2. RTC View View the Date & Time