Sartorius Cubis MCE - Page 22

22 Operating Instructions Cubis
®
MCE
Operating Concept
Symbol Name Description
[Leveling] button Starts a leveling process.
[GLP] button − Exits the GLP printout and starts printing the GLP footer.
− If the “Net-total”, “Totalizing”, or “Statistics” application is active:
Prints and deletes the saved values and exits the application.
[Toggle between weight units]
button
If the “Toggle between weight units” function is active:
− If the button is held down: Accesses the “Toggle between weight
units” function menu.
− When the button is pressed: Switches between the basic unit
display and up to 4 other units.
[Invalid weight value] button If a fault exists in the weighing module: Indicates the cause of this
fault.
[Back] button − In the menu:
− When the button is pressed: Returns to the previous display.
− If the button is held down: Saves the menu settings.
− When entering digits: Selects the previous digit position.
− For an active application: Exits the application and deletes the
set reference value.
[Up] button − In the menu: Scrolls through the menu levels or the available
configuration values.
− When entering digits: Increases the displayed value.
[Down] button − In the menu: Scrolls through the menu levels or the available
configuration values.
− When entering digits: Decreases the displayed value.
− In the main display of an active application: Accesses the display
to set the reference values.
[Confirm] button − In the menu: Accesses the displayed menu level or confirms the
displayed configuration value.
− When entering digits: Selects the next digit position.
− In the main display of an active application: Starts the applica-
tion process and saves the set reference value.
[On | Off] key − If the key is briefly pressed: Switches the operating display on.
− If the key is held down: Switches the operating display off.
[Zero] key Zeros the device.
[Tare] key Starts taring.
[Print] key Exports the readouts to the integrated data interfaces.
[Change] key − For models with a motorized draft shield: Opens or closes the
doors on the draft shield.
− For models without a motorized draft shield, if the “Toggle
between weight units” function is active:
− If the key is briefly pressed: Switches between the set weight
units.
− If the key is held down: Accesses the “Toggle between weight
units” function menu.