Sartorius Cubis MCE - Performing a Software Update

72 Operating Instructions Cubis
®
MCE
Cleaning and Maintenance
9.6 Performing a Software Update
A software update can be installed from a USB mass storage device using
the device’s USB-A connection.
Requirements
− The device is switched on.
− The software update is saved on a USB mass storage device.
Procedure
t Download the software update from the Sartorius website onto the USB
mass storage device.
t If this relates to a zip file: Unzip the software update on the stick.
t Insert the USB mass storage device with the software update into the
device’s USB-A connection.
t Access the configuration menu and select the “UPDATE” main menu.
t In the “UPDATE” main menu, select the “EXECUTE?” parameter.
y The [COPYING] display appears in the operating display.
y The [REBOOT] display appears in the operating display and the device
restarts.
y The [UNPACK] display appears in the operating display.
y The [RESTART] display appears in the operating display and the device
restarts.
y During the restart, the [CHECK.APC] display appears first. The [PROG
APC] display then appears in the operating display for about 2 minutes.
t Do not switch off the device!
y The device confirms successful installation with the [PROG OK] display.
y All identified components are updated with the new firmware.
y The device confirms the end of the installation process with the [FINISH]
display.
y The device restarts.
y The device is ready for use.