32 Operating Instructions Cubis
®
MCE
Installation
5.2 Selecting an Installation Site
Procedure
t Ensure that the following conditions are met at the installation site:
Condition Features
Ambient conditions Suitability tested (see Chapter “15.3 Ambient
Conditions”, page 82)
Setup surface Stable, even surface that is not exposed to vi-
brations
Not directly against a wall
Sufficiently dimensioned for the device and the
peripheral devices (device space requirements
see Chapter “15.1 Dimensions and Weight”,
page 80; peripheral device space require-
ments see instructions for the peripheral devic-
es, e.g. printer)
Sufficient load-bearing capacity for the device
and the peripheral devices even when full (de-
vice weight see Chapter “15.1 Dimensions and
Weight”, page 80; weight of the peripheral
devices see instructions for the peripheral de-
vices, e.g. printer)
Access Barrier-free
5.3 Unpacking the Device
Procedure
t Lift the device in the Styrofoam padding out of the packaging.
t Place the device in the Styrofoam padding on its side.
t Lift the Styrofoam padding off the device.
t
CAUTION Glass breakage due to the incorrect handling of the
device! Do not lift the device using the draft shield. Only lift the device
by its base.
t Place the device on its base.
t Keep all parts of the original packaging, e.g. to return the device.
To Next Page
Loading...
