Sartorius Cubis MCE - Parameters in the Applications Main Menu

54 Operating Instructions Cubis
®
MCE
System Settings
7.3.4 Parameters in the “Applications” Main Menu
Parameters in the “Weighing” Submenu
Parameters Setting values Explanation
UNIT OFF Deactivates the “Toggle between weight units” function.
ON* Activates the “Toggle between weight units” function.
* Factory setting
Parameters in the “Counting” Submenu
Parameters Setting values Explanation
RESOLUT. DISP.ACC.* − Sets the resolution to “display resolution”.
− The “Counting” application is started with the displayed value.
10-FOLD Sets the resolution to 10-times more accurate than “display resolution”.
100-FOLD Sets the resolution to 100-times more accurate than “display resolution”.
REF.UPDT. OFF* Deactivates automatic reference sample updating.
AUTO Activates the automatic reference sample updating.
* Factory setting
Parameters in the “Weighing in Percent” Submenu
Parameters Setting values Explanation
DEC.PLCS NONE The result of the “Weighing in Percent” application is displayed without
decimal places.
1 DEC.PL.* The result of the “Weighing in Percent” application is displayed to 1 decimal
place.
2 DEC.PL. The result of the “Weighing in Percent” application is displayed to 2 decimal
places.
3 DEC.PL. The result of the “Weighing in Percent” application is displayed to 3 decimal
places.
* Factory setting
Parameters in the “Net-Total” Submenu
Parameters Setting values Explanation
COMP.PRT. OFF Deactivates the component printout.
ON* Activates the component printout.
* Factory setting