Sartorius Cubis MCE - Page 55

Operating Instructions Cubis
®
MCE 55
System Settings
Parameters in the “Totalizing” Submenu
Parameters Setting values Explanation
COMP.PRT. OFF Deactivates the component printout.
ON* Activates the component printout.
* Factory setting
Parameters in the “Animal Weighing” Submenu
Parameters Setting values Explanation
ACTIVITY CALM − Sets the intensity of the “Animal activity” to “calm”.
− Recommended for minor movements of the sample, e.g. caused by
placement on the weighing pan.
MEDIUM* − Sets the intensity of the “Animal activity” to “medium”.
− Recommended for medium movements of the sample, e.g. caused by
placement on the weighing pan.
V.ACTIVE − Sets the intensity of the “Animal activity” to “very active”.
− Recommended for very active movements of the sample, e.g. caused by
placement on the weighing pan.
START MANUAL The “Animal weighing” application must be manually selected in the start
screen.
AUTO* Sets the trigger to start the “Animal weighing” application to “automatic”.
* Factory setting
Parameters in the “Calculation” Submenu
Parameters Setting values Explanation
METHOD MUL.* Specifies multiplication as the method of calculation for the “Calculation”
application.
DIV. Specifies division as the method of calculation for the “Calculation” application.
DEC.PLCS NONE The result of the “Calculation” application is displayed without decimal places.
1 DEC.PL.* The result of the “Calculation” application is displayed to 1 decimal place.
2 DEC.PL. The result of the “Calculation” application is displayed to 2 decimal places.
3 DEC.PL. The result of the “Calculation” application is displayed to 3 decimal places.
* Factory setting