Operating Instructions Cubis
®
MCE 71
Cleaning and Maintenance
Procedure
t NOTICE Malfunction or damage to the device due to the ingress of
moisture or dust!
t Remove dust and powdery sample residue with a brush or hand-held
vacuum cleaner.
t NOTICE Corrosion or damage to the weighing pan due to unsuitable
cleaning agents!
t Wipe down the balance base, the shield plate, and the weighing pan
with a cleaning agent and a cloth. The cleaning agent must be
suitable for stainless steel and titanium.
t Wipe the associated components of the weighing pan with a brush or a
damp cleaning cloth, e.g. shield plate, support pan.
t Wipe the device housing with a damp cloth. For more severe
contamination, use a mild soap solution.
t If this relates to a device with an analytical draft shield or flat glass draft
shield: Wipe the weighing chamber with a damp cloth. For more severe
contamination, use a mild soap solution.
Tip
We recommend cleaning the weighing pan on a regular basis, e.g. weekly.
Do not allow deposits to form on the weighing pan.
Protective oil may be applied to the weighing pan for additional protection.
The protective oil must be suitable for stainless steel and titanium.
9.4 Assembling and Connecting the Device
Procedure
t Re-insert all components into the device (for insertion, see
Chapter “5.6 Installing a Device with an Analytical Draft Shield or
Flat Glass Draft Shield”, page 35, Chapter “5.7 Installing a Device
with a Frame Draft Shield”, page 38).
t Re-connect the device to the power supply (see
Chapter “6.3 Connecting the Power Supply”, page 42).
9.5 Maintenance Schedule
Interval Component Action Chapter, page
Monthly to every 2 years, depending
on the operating conditions
Entire system Contact Sartorius Service 17, 95
To Next Page
Loading...
