70 Operating Instructions Cubis
®
MCE
Cleaning and Maintenance
t If this relates to a device with a flat glass draft shield: Press and hold
the locking button (1) on the door handle and pull the side panels
completely out of the guide rails.
t To remove the upper panel: Press and hold the locking button (1) on the
door handle and pull the upper panel completely out of the guide rails.
9.2 Preparing a Device with a Frame Draft
Shield
Procedure
t Turn the device off.
t Disconnect the device from the power supply. To do so, disconnect the
power supply cable from the wall outlet.
t Remove the frame draft shield (1) and clean it with a brush or a damp
cleaning cloth.
t Remove the weighing pan (2).
t Remove the shield plate (3) and pan support (4)
9.3 Cleaning the Device
NOTICE
Corrosion or damage to the device due to unsuitable cleaning agents!
t Do not use corrosive, chloride-containing, or aggressive cleaning agents.
t Do not use cleaning agents that contain abrasive ingredients, e.g.
scouring agents, steel wool.
t Do not use solvent-based cleaning agents.
t Check whether the cleaning agents used are compliant materials (see
Chapter “15.4 Materials”, page 84).
t Make sure that cleaning materials, such as cloths, are only slightly damp.
1
1
1
2
3
4
To Next Page
Loading...
