56 Operating Instructions Cubis
®
MCE
System Settings
Parameters in the “Density Determination” Submenu
Parameters Setting values Explanation
DEC.PLCS NONE The result of the “Density determination” application is displayed without
decimal places.
1 DEC.PL.* The result of the “Density determination” application is displayed to 1 decimal
place.
2 DEC.PL. The result of the “Density determination” application is displayed to 2 decimal
places.
3 DEC.PL. The result of the “Density determination” application is displayed to 3 decimal
places.
* Factory setting
Parameters in the “Statistics” Submenu
Parameters Setting values Explanation
COMP.PRT. OFF Deactivates the component printout.
ON* Activates the component printout.
TAR./STAT. OFF* Deactivates automatic taring after the components are saved.
ON Activates automatic taring after the components are saved.
* Factory setting
7.3.5 Parameters in the “Input” Main Menu
Parameters Setting values Explanation
ID NO. Maximum of
8 characters
09-0, A-Z, - ,
space
Saves the entered ID number for the device.
LOT ID OFF* Deactivates the output of a line for the lot ID number for the GLP printout.
ON − Activates the output of a line for the lot ID number for the GLP printout.
− The LOT-ID can be entered in writing in the line.
DATE Saves the entered date.
TIME Saves the entered time.
USER.PASS. Maximum of
8 characters
09-0, A-Z, - ,
space
Saves the entered user password.
DEL.PASS. YES Deletes the entered user password.
NO* Does not delete the entered user password.
* Factory setting
To Next Page
Loading...
